Registering your Cellular Booster
Rules from the FCC went into effect on May 1, 2014 - outlawing sales of older booster models and paving the way for a the new generation of cellular boosters designed to reduce the potential for causing interference to wireless networks.
Waiting for these new standards and the accompanying certification process had essentially
frozen the market for cellular boosters, holding back new models for over a year.
If you're a member, please log in above to access the exclusive portions of our content.
We are honored to be able to present a bunch of our content for free.
Our resource center is brought to you by funding from our premium members. We don't accept 3rd Party Advertising, we're not sponsored and we don't sell stuff.
Our members have exclusive access to in-depth content, classrooms, discounts, alerts, insider info and interactive guidance.
If mobile internet is an important part of your lifestyle, you can help make this possible:
And after that year, new boosters all now come with a scary mandated warning label:
“BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.”
All the major carriers have issued blanket consent for the use of the new generation of FCC-approved boosters on their network, so you don't need to ask any of the big four for permission.
But that doesn’t get you off the hook from registering - technically.
However, over the years since the regulation came out, we've seen no active enforcement on the policy. Under the revised FCC, booster registration may still be on the books as a requirement - but it may matter less than ever that you make the effort to register.
If you decide to register - How? Where?
And what will happen to you if you don’t register?
And these rules, even years later, are still confusing and often unknown even to the “advanced” support desks at the major wireless carriers. Calling and asking for advice about "booster registration" will just get you sometimes hilariously inaccurate and often conflicting information. Stopping in to the carrier stores will just get you blank stares.
We’ve done the research and have tracked down all the critical details for all of the major carriers. Read on for the definitive guide to booster registration.
Cellular Carrier Registration
AT&T’s booster registration form requests the owner’s name, operator’s name (if different), contact phone number, booster make, model, and serial number, date of initial operation, and installed location.
AT&T references use in “recreational vehicles” in the FAQ - but AT&T offers no clarification on what you should enter for the “booster location” if your location is going to be changing regularly. Use your mailing address, wherever that may be.
A literal reading of the AT&T FAQ also seems to imply that older boosters are no longer authorized:
“After March 1, 2014, only FCC certified or carrier approved signal boosters may be operated on the AT&T network."
AT&T is the only carrier that is taking a "no old boosters unless explicitly approved" stance - a very sharp contrast to Verizon's openness.
AT&T's booster registration page: https://securec45.securewebsession.com/attsignalbooster.com/
Verizon has a much more thoroughly developed registration process than any of the other carriers, with a nice FAQ and even an explicit (tentative) approval for older booster models:
“Verizon also tentatively approves the use of consumer signal boosters that do not meet the new network protection standards. This approval is provided only for the boosters not causing interference and may be revoked if the particular booster or booster model is found to cause interference issues. To help avoid possible interference issues, however, Verizon recommends that customers who need signal boosters replace existing boosters as soon as possible with consumer signal boosters that meet the new network protection standards.”
Verizon also gives instructions for how mobile boosters should be registered:
“For mobile boosters in a car, RV or boat use the address where the vehicle will be stored or parked like the home address or marina in the case of a boat."
This is a start - but what about full-timers who never "store or park" their home on wheels?
Verizon's booster registration page: http://www.verizonwireless.com/wcms/consumer/register-signal-booster.html
There is no information given on whether old boosters are approved (though very few actually fully supported by T-Mobile fully anyway), but presumably, they are ok to register and use.
And just like AT&T, T-Mobile seems to have no conception of boosters that lack a fixed “use address”.
Unique to T-Mobile is a request for the "number of users" that will be using a booster.
T-Mobile's booster registration page: http://support.t-mobile.com/docs/DOC-9827
Sprint, post-merger, now forwards their booster registration page to T-Mobile.
MVNOs, Resellers, and Prepaid for All Carriers
In all likelihood - you don't need to register your booster with an MVNO, reseller or prepaid provider if you are using it with one of their plans.
With less and less focus on even the major carriers collecting booster registration information, their resellers and MVNOs are even less inclined to facilitate this process. If you're utilizing a reseller, you can see if they are registering boosters. But don't stress too much over it. Seriously. Don't stress about it - just use the booster.
Booster Registration FAQs:
Initially, registering was demonstrating the demand and need for cellular boosters. So many boosters are now on the market that the need for registering is likely just not there anymore.
The primary purpose of the registration databases being built is to help with network troubleshooting issues. If a defective booster is wreaking havoc on the network, the registration info may help carriers track down and isolate the problem before it causes too much interference.
There really isn’t a downside to registering, other than just a little bit of hassle.
BTW, here is the official FCC justification:
“Registration is a key element in providers’ ability to control the devices that operate on their network. Registration is also one way for subscribers to obtain and demonstrate that they have provider consent. Further, registration will assist providers in locating problematic boosters in the event interference occurs and will facilitate consumer outreach. We find that the benefits associated with a provider-based registration system (e.g., provider control of devices, rapid interference resolution, ease of consumer outreach) outweigh the costs of such a system.”
What if I do not register?
You will not be fined or hauled off to jail. But you might be required to cease and desist if your booster is caught causing any network issues.
AT&T sure doesn't sound too threatening here: “The operator of an illegal signal booster could be required to stop operation of the device."
This general leniency only applies to “consumer boosters”. If you install a booster labeled for “industrial use” without having documented explicit permission from a carrier, you may be facing “penalties in excess of $100,000”.
And if you ignore a request from the FCC or any licensed carrier to stop using a booster that is causing interference… well, then you are just asking for trouble.
Here is what the FCC has to say:
“At this time, the FCC likely will not pursue enforcement against current or prospective signal booster users unless it involves an instance of unresolved interference. If a wireless licensee or the FCC asks you to turn off your signal booster because it is causing interference to a wireless network, however, you must turn off your booster and leave it off until the interference problem can be resolved."
Is this just a ploy to eventually outlaw boosters?
"If cellular boosters are outlawed, only outlaws will have good signal..."
Actually - the FCC rules point to a long and bright future for cellular boosters. Old booster designs could cause serious network interference issues, and they were already operating in a legal grey area by transmitting without authorization on airways that are licensed by the various cellular carriers.
The cellular carriers, FCC, and booster manufacturers came together to define new technical and operational standards to minimize interference so that boosters could continue to help users in fringe areas while avoiding causing issues everywhere else.
The 2014 FCC webmaster was clearly a fan of boosters - notice the page title for the FCC consumer booster information page: "Signal Boosters are the Greatest Thing Since Sliced Bread" (seriously!)
This page is now gone from the internet, presumably, the new FCC doesn't like sliced bread or care about boosters.
What is required to register?
All the registration forms we tracked down request some subset of the following information - owner’s name, operator’s name (if different), contact phone number, booster make, model, and serial number, date of initial operation, and installed location.
Some of the forms ask whether the booster will be “mobile” or installed at a “fixed location”, but many of them seem to not have considered mobile users - especially mobile users without a fixed location home base.
In those cases - the best thing to do is to use your mailing address.
What if I have multiple devices on multiple networks?
Most boosters are not carrier-specific. Most are nearly “universal” supporting boosting on most of the major carriers. So - who should you register with?
The guidance from the FCC says that you should register with every carrier where you will regularly be connected. You need to register once per booster per carrier - it does not matter how many devices you are connecting.
What about friends who use my booster? Guests?
The FCC has ruled that it is perfectly fine for friends and visitors on other carriers to take advantage of your booster without explicitly registering. But if you have a housemate who is making regular use of your booster, they should register with their carrier too.
Straight from the FCC:
“In some instances, a subscriber may be authorized to operate a Consumer Signal Booster to connect to his/her wireless provider and a third party may also wish to use the booster occasionally to connect to the third party’s wireless provider. Examples include a visitor in a home or guest in a vehicle. We view these occasional, incidental uses as de minimis and authorize them under the license of the third-party user’s serving provider.” ... “If a third party intends to use a Consumer Signal Booster on a regular, sustained basis, the third party must seek its provider’s consent to do so.”
What is the deal with the E911 warning?
The E911 system provides the location of your cell phone to 911 dispatch automatically when you make an emergency call. This system works in part by cell tower triangulation. With a booster thrown into the mix, it is possible for this triangulation process to get confused and to think that you are closer to the cell towers than you actually are. If you are on a booster and call 911, be sure to confirm that the dispatch operator has your actual location.
Can I change around antennas?
One of the other stipulations of the new FCC rules is that consumer boosters can no longer be sold other than as part of a kit that includes all necessary wires and antennas. This is meant to ensure that whatever is installed matches what was submitted to the FCC for testing.
There is nothing that technically prevents an end-user from changing around antennas at a later date, and the rules do allow for booster antenna upgrade kits to be sold as well. But to stay compliant - all additional antennas should at least meet manufacturer specifications.
Here is the official FCC rule:
“Our antenna kitting rules require a manufacturer to sell Consumer Signal Boosters (fixed and mobile) together with all necessary antennas, cables, and/or coupling devices. This requirement is not intended to preclude equipment options, such as upgraded antennas or other equipment options, to be offered with the Consumer Signal Booster purchase or with an after purchase upgrade, but all equipment options and features must be tested to ensure the Network Protection Standard is met. This requirement ensures that consumers have the appropriate special accessories when they purchase a Consumer Signal Booster and that after purchase upgrades still comply with the necessary requirements. We do not require consumers to use Consumer Signal Boosters only with these manufacturer-provided special accessories to allow for future replacement due to damage, loss, upgrade, etc. Consumers must nonetheless use any Consumer Signal Booster with manufacturer-specified special accessories.”
In other words - if you want to use a different antenna with a booster, contact the manufacturer for advice and recommendations. Both Wilson Electronics and Maximum Signal offer special "RV Kits" with antennas to go along with their new mobile boosters.
If you choose to use an antenna that has not been officially tested with your booster, try at least to match the specifications of similar antennas that have been.
A Final Reminder
Always remember - if you ever get a knock asking you to shut down your booster because you are causing interference, do it.
And yes, your location can be triangulated if your booster is causing network interference. They will find you.
Even if you are using an FCC compliant booster with the stock provided antennas, you are required to comply with any FCC or licensed operator requests to shut down if you are causing interference. It is the neighborly thing to do too - a technician would not have been sent out to triangulate your location without a good reason.
We've had a friend who has "gotten the knock" (with an old-style booster), and the FCC tech was actually incredibly friendly and even gave him advice on how to reconfigure his system to avoid interference.
And that just means... more signal for everyone!
Summary: Registration is Helpful but Not Mandated
All new boosters will come with a mandated warning label saying you must register your device. However, all major carriers have issued blanket consent for the new generation of boosters, so you don't actually need to ask permission.
Registration was initially to demonstrate demand, but now it helps with network troubleshooting. While you technically should register your booster, we've seen no active enforcement of this requirement. There is no real downside to registering, other than just minor hassle.
If you don't register, you won't get in trouble, but you may be required to cease and desist if your booster causes any network issues.
Explore the Resource Center
Join our 'Library Desk':
Internet for RVers & Cruisers Facebook Group
We cross post news articles and guides, and can help point you in the right direction to our content here on the resource center.
It is with gratitude to our premium members that we're able to offer our free content - and for that, they also have access our private Q&A areas for more in-depth guidance.
Become a Member
The MIA is our premium membership - designed for those who consider mobile internet an important part of their lifestyle.
In thanks for making content like this possible, we offer a bunch of additional perks. From interactive guidance, in-depth member exclusive content, discounts, alerts, classroom and more.
Become a Supporter
We totally understand that a membership isn't right for everyone.
However you can still support this content with our supporter level for just $25/year.
With our gratitude, you'll get access to all our free content without the 'nags'.